Part Number: HL 22065

Take Down Garden Spray Pint (6Cs)

SUPERthrive Pint (12/Cs)

SUPERthrive 4 oz (12/Cs)

Super Sprouter® 50 Cell Square Plug Insert Tray is the perfect tray insert for coco plugs, regular soil, or soilless mixes for seeds or cuttings. Fits into all standard 10 x 20 in flats.

These Pipettes, unlike their glass counterparts, will not shatter or break. These disposable Pipettes are used only once, the chances for infectious material being passed on is reduced. Measure Master® Pipettes will work well whenever there is a need for quick, safe transfer of liquids. Packaged individually in sterile packets, these disposable pipettes fit almost all needs for liquid transfer.

Measure Master Sterile Disposable Pipette 3 ml (20/Box)

Perfect for hydroponic gardens requiring up to 150 gallons a day of pure reverse osmosis water.

• Produces up to 150 GPD (gallons per day) of ultra-pure, low PPM water (Flow rates of RO systems are based on source water @ 65 psi/77°/500 ppm)
• Removes up to 98%+ of all contaminants
• 50% water savings over similar RO filters with your choice of 1:1 or 2:1 ratios
• The #1 selling filter in gardening and hydroponics for 10+ years
• Membrane Power Flush Kit now included

• Reduces up to 99% chlorine, sediment, rust, silt, volatile organic compounds (VOCs), mercury, lead and PCBs (organic chlorine)
• Rated at 1 GPM (gallons per minutes)
• 10 micron nominal filtration
• No release of carbon fines
• Reduced rinse time due to carbon fines
• Greater dirt load capacity and flow efficiencies
• Industry leading performance
• Made in the USA
• smallBoy: Replace after 3,000 gallons
• Stealth-RO: Replace after 1,250 gallons

• 98+% PPM Rejection
• 1 membrane for stealth-RO150 and 2 membranes for the stealth-RO300
• Filters up to 150 GPD (gallons per day)
• Replace between 6 months to 2 years

THERE ARE TWO INDICATIONS AS TO WHEN TO CHANGE YOUR MEMBRANES

1. Test the RO and source/inlet water to see what percentage of the inlet water’s PPM the Stealth-RO150 is filtering out (rejection %). You should see approximately 98% of the inlet PPMs being removed when the membrane is new. If the rejection % falls under an acceptable level (typically 90%) it’s time to change the membrane
2. When the flow rate of the product water slows down significantly. This can also happen if your pre-filters are clogged. If you change your pre-filters and the product water still flows slowly then it’s an indication you need a new membrane. When it doubt contact HydroLogic

Flow rates of RO systems are based on source water @ 65 psi / 77° / 500 ppm

• Reduces silt, rust, dirt, sand, and sediment
• Clean regularly and replace between 6 to 12 months

STACK!T Hanging Dry Rack w/28 Clips